Filter
Top Products
68
Chapter 2 Using the XV-3080 Effects
Thre (Reset Threshold)
Sets the volume level at which the reset begins.
Mon (Reset Monitor)
Determines whether the sound used as the reset trigger is
output (ON) or not (OFF). This parameter is disabled when
Reset is set to OFF or Source.
Mode
Sets the manner in which the volume changes as one beat
progresses to the next.
LEGATO:The change in volume from one beat’s level to the
next remains unaltered. If the level of a following beat is the
same as the one preceding it, then there is no change in
volume.
SLASH:The level is momentarily set to 0 before progressing
to the level for the next beat. This change in volume occurs
even if the level of a following beat is the same as the one
preceding it.
Shuffle #
Sets the timing of volume changes in levels for even-
numbered Beats (Beat 1-2/Beat 1-4/Beat 2-2/...). The higher
the value selected, the later the timing with which the beat
progresses.
Level (Output Level)
Adjust the output level.
59:ISOLATOR
An equalizer which cuts the volume greatly, allowing you to
add a special effect to the sound by cutting the volume in
varying ranges.
fig.2-69
Level High #
Level Middle #
Level Low #
These boost and cut each of the High, Middle, and Low
frequency ranges. At -60 dB, the sound becomes inaudible. 0
dB is equivalent to the input level of the sound.
Anti Phase Mid (Anti Phase Middle Switch/
Level)
This turns the Anti-Phase function on and off and sets the
level settings for the Middle frequency ranges. When turned
on, the counter-channel of stereo sound is inverted and
added to the signal. Adjusting these levels for certain
frequencies allows you to lend emphasis to specific parts.
(This is effective only for stereo source.)
Anti Phase Low (Anti Phase Low Switch/Level)
This turns the Anti-Phase function on and off and sets the
level settings for the Low frequency ranges. When turned on,
the counter-channel of stereo sound is inverted and added to
the signal. Adjusting these levels for certain frequencies
allows you to lend emphasis to specific parts. (This is
effective only for stereo source.)
Low Boost (Low Booster Switch/Level)
Adjust whether Low Booster will be used (ON) or not (OFF).
This emphasizes the bottom to create a heavy bass sound.
And adjust the level. Increasing this value gives you a
heavier low end. (Depending on the Isolator and filter
settings this effect may be hard to distinguish.)
Level (Output Level)
Adjust the output level.
60:3D CHORUS
This applies a 3D effect to the chorus sound. The chorus
sound will be positioned 90 degrees left and 90 degrees right.
fig.2-70
Pre Dly (Pre Delay Time)
Adjust the delay time from the original sound until when the
chorus sound is heard.
Rate (LFO Rate) #
Adjust the modulation frequency of the chorus sound.
Depth (LFO Depth)
Adjust the modulation depth of the chorus sound.
L in
R in
L out
R out
Isolater
Low Boost
Low Boost
Isolater
L
R
3D Chorus
2-Band
EQ
2-Band
EQ
R out
L out