Filter
Top Products
42
Chapter 2 Using the XV-3080 Effects
9: COMPRESSOR
The Compressor flattens out high levels and boosts low
levels, smoothing out unevenness in volume.
fig.2-12
Attack
Adjust the attack time of an input sound.
Sustain
Adjust the time over which low level sounds are boosted
until they reach the specified volume.
Post Gain
Adjust the output gain.
LowGain
Adjust the low frequency gain.
Hi Gain
Adjust the high frequency gain.
Pan (Output Pan) #
Adjust the stereo location of the output sound. L64 is far left,
0 is center, and 63R is far right.
Level (Output Level) #
Adjust the output level.
10: LIMITER
The Limiter compresses signals that exceed a specified
volume level, preventing distortion from occurring.
fig.2-13
Thresh (Threshold Level)
Adjust the volume at which compression will begin.
Ratio (Compression Ratio)
Adjust the compression ratio.
Release (Release Time)
Adjust the time from when the volume falls below the
Threshold Level until compression is no longer applied.
Gain (Post Gain)
Adjust the output gain.
LowGain
Adjust the low frequency gain.
Hi Gain
Adjust the high frequency gain.
Pan (Output Pan) #
Adjust the stereo location of the output sound. L64 is far left,
0 is center, and 63R is far right.
Level (Output Level) #
Adjust the output level.
11: HEXA-CHORUS
Hexa-chorus uses a six-phase chorus (six layers of chorused
sound) to give richness and spatial spread to the sound.
fig.2-14
Pre Dly (Pre Delay Time)
Adjust the time delay from when the direct sound begins
until the chorus sound is heard.
Rate #
Adjust the rate of modulation.
Depth
Adjust the depth of modulation.
Dly Dev (Pre Delay Deviation)
Pre Delay determines the time from when the direct sound
begins until the processed sound is heard. Pre Delay
Deviation adjusts the differences in Pre Delay between each
chorus sound.
Dpt Dev (Depth Deviation)
Adjust the difference in modulation depth between each
chorus sound.
Pan Dev (Pan Deviation)
Adjust the difference in stereo location between each chorus
sound. With a setting of 0, all chorus sounds will be in the
center. With a setting of 20, each chorus sound will be spaced
at 60 degree intervals relative to the center.
Balance (Effect Balance) #
Adjust the volume balance between the direct sound and the
chorus sound. With a setting of D100:0W only the direct
L in
R in
L out
R out
Pan R
Pan L
Compressor
2-Band
EQ
L in
R in
L out
R out
Pan R
Pan L
Limiter
2-Band
EQ
Balance W
Balance W
L in
R in
L out
R out
Hexa Chorus
Balance D
Balance D