Filter
Top Products
64
Chapter 2 Using the XV-3080 Effects
Level (Output Level)
Specifies the output volume.
50:LOFI COMPRESS
This is an effect that intentionally degrades the sound
quality.
fig.2-60
Type (LoFi Type)
Lowers the audio quality. The audio quality will worsen as
this setting is increased.
Pre Filter (Pre Filter Type)
Adjust the type of filter that will be applied before the sound
passes through the Lo-Fi effect.
Post Filter 1 (Post Filter 1 Type)
Adjust the type of filter that will be applied after the sound
passes through the Lo-Fi effect.
Post Filter 2 (Post Filter 2 Type/Cutoff
Frequency)
OFF:A post filter 2 will not be used.
LPF:The frequency region above the Cutoff Freq setting will
be cut.
HPF:The frequency region below the Cutoff Freq setting will
be cut.
Sets the cutoff frequency when a specific frequency band is
cut off by a filter.
LowGain
Adjust the low frequency gain (amount of boost or cut).
Positive (+) settings will emphasize (boost) the low
frequency range.
Hi Gain
Adjust the high frequency gain (amount of boost or cut).
Positive (+) settings will emphasize (boost) the high
frequency range.
Balance (Effect Balance) #
Sets the volume balance between the source sound and the
effect sound.
With a setting of D100:0W only the direct sound will be
output, and with a setting of D0:100W only the effect sound
will be output.
Pan (Output Pan)
Adjust the stereo location of the output sound. A setting of
L64 is far left, 0 is center, and 63R is far right.
Level (Output Level)
Adjust the output level.
51:LOFI NOISE
In addition to a Lo-Fi effect, this effect also generates various
types of noise, such as radio noise and disc noise.
fig.2-61
Type (LoFi Type)
Lowers the audio quality. The audio quality will worsen as
this setting is increased.
Post Fltr (Post Filter Type/Cutoff Frequency)
OFF:A filter will not be used.
LPF:The frequency region above the Cutoff Freq setting will
be cut.
HPF:The frequency region below the Cutoff Freq setting will
be cut.
And adjust the frequency at which the filter will begin
cutting.
Radio Detune (Radio Detune#/Radio Noise
Level)
Simulates the tuning noise of a radio. As this value is raised,
the tuning will drift further.
And adjust the volume of the radio noise.
Disc:LPF:Lev(Disc NoiseType:Disc Noise
LPF:Disc Noise Level)
Disc:Selects the type of record noise. The frequency at which
the noise is heard will depend on the selected type.
LPF:Adjust the cutoff frequency of the low pass filter that is
applied to the record noise.
Level:Adjust the volume of the record noise.
LowGain
Adjust the low frequency gain (amount of boost or cut).
Positive (+) settings will emphasize (boost) the low
frequency range.
Lo-Fi
2-Band
EQ
L in
R in
L out
R out
Pan R
Pan L
R in
R out
L in
L out
Lo-Fi
Lo-Fi
2-Band
EQ
2-Band
EQ
Noise Gen.
Radio