Filter
Top Products
58
Chapter 2 Using the XV-3080 Effects
Res (Phaser Resonance)
Adjust the amount of feedback for the phaser. Higher
settings will give the sound a stronger character.
X-Fbk (Cross Feedback Level)
Adjust the proportion (%) of the phaser sound that is to be
returned to the input. Positive (+) settings will return the
signal to the input with the original phase, while negative (-)
settings produce an inverted phase.
Step Rate (Step Rate Switct/Step Rate #)
Adjust the frequency of pitch change.
This setting determines whether the pitch is changed in a
stepped fashion (ON) or not (OFF).
Mix (Mix Level)
Adjust the volume of the phase-shifted sound, relative to the
direct sound.
Low Gain
Adjust the low frequency gain (amount of boost or cut).
Positive (+) settings will emphasize (boost) the low
frequency range.
Hi Gain
Adjust the high frequency gain (amount of boost or cut).
Positive (+) settings will emphasize (boost) the high
frequency range.
Level (Output Level)
Adjust the output level.
42:KEYSYNC FLANGER
Keysync FLanger controls the Flanger by resetting the effect
at the volume of the sound input to the effects device,
restarting from the same pitch each time the Flanger is reset.
This parameter lets your playing dynamics on the keyboard
control the flanger effect.
fig.2-52
Pre Dly (Pre Delay Time)
Adjust the time delay from the original sound until the
flanger sound is heard.
Rate (LFO Rate) #
Adjust the modulation frequency of the flanger sound.
Depth (LFO Depth)
Adjust the modulation depth of the flanger sound.
Fbk (Feedback) #
Adjust the proportion (%) of the flanger sound that is to be
returned to the input. Positive (+) settings will return the
signal to the input with the original phase, while negative (-)
settings produce an inverted phase. Higher settings will
produce a more distinctive sound.
Phase 0–180 [deg]
Adjust the spaciousness of the flanger sound.
Filter (Filter Type)
OFF:A filter will not be used.
LPF:he frequency region above the Cutoff Freq setting will
be cut.
HPF:The frequency region below the Cutoff Freq setting will
be cut.
Cutoff(Cutoff Frequency)
Sets the cutoff frequency when a specific frequency band is
cut off by a filter.
Step Rate (Step Rate Switct/Step Rate #)
Adjust the frequency of pitch change.
This setting determines whether the pitch is changed in a
stepped fashion (ON) or not (OFF).
R in
R out
L in
L out
Flanger
Feedback
Feedback
Flanger
2-Band
EQ
2-Band
EQ