Filter
Top Products
79
Chapter 3 Selecting Output Jacks
Chapter 3
RHYTHM MFX OUT ([RHYTHM]-
[EFFECTS])
Output (Output Assign) A/B/C
This specifies the OUTPUT jacks to which the stereo Multi-
Effects unit’s output is routed.
Dry (Dry Output Level) 0–127
This sets the output level of the Multi-Effects to the selected
OUTPUT jacks.
Chorus (Chorus Send Level) 0–127
This sets the amount of the Multi-Effect unit’s output to be
sent to the Chorus. Its final output destination is determined
by the Chorus output setting.
Reverb (Reverb Send Level) 0–127
This sets the amount of the Multi-Effect unit’s output to be
sent to the Reverb. Its final output destination is determined
by the Reverb output setting.
RHYTHM CHO OUT ([RHYTHM]-
[EFFECTS])
Output Assign (Chorus Output Assign) A/B/C
This setting selects the pair of OUTPUT jacks to which the
Chorus unit’s stereo output is routed when Chorus Output
Select is set to “MAIN” or “MAIN+R.”
Level (Chorus Level) 0–127
This setting determines the Chorus output level.
Select (Chorus Output Select)
This parameter allows you to send the Chorus output
directly to the currently selected OUTPUT jacks, to the
Reverb, or to both.
MAIN: The Chorus output is sent only to the OUTPUT jacks.
REV: The Chorus output is sent only to the Reverb.
MAIN+R: The Chorus output is sent to the OUTPUT jacks
and to the Reverb.
RHYTHM REV OUT ([RHYTHM]-
[EFFECTS])
Output Assign (Reverb Output Assign) A/B/C
This specifies the OUTPUT jacks to which the Reverb unit’s
stereo output is routed.
Level (Reverb Level) 0–127
This specifies the overall volume of the Reverb.
SYSTEM SETUP ([SYSTEM]-[COMMON])
Master Level 0–127
This adjusts the volume of the entire XV-3080.
Mix/Parallel
MIX: All Rhythm Tones – including those routed to
OUTPUTs B/C or INDIVIDUAL 3–6 – are mixed together
and routed to the A(MIX) OUTPUT jacks.
This setting allows you to quickly route everything through
headphones when you are creating sounds, or to combine all
of your Rhythm Tones into two outputs when sending the
XV-3080’s signal to a mixer that has only two channels.
* When MIX is selected, Rhythm Tones routed to the
INDIVIDUAL 3/5 jacks are sent to the left A(MIX)
OUTPUT jack, and Rhythm Tones routed to the
INDIVIDUAL 4/6 jacks are sent to the right A(MIX)
OUTPUT jack.
PARALLEL: Rhythm Tones are routed to output jacks
according to their output settings.
* The XV-3080’s Master Level and Mix/Parallel settings are
each established using a single global parameter.
Example of Settings
Setting the Output Destination of a
Specific Rhythm Tone
This example explains the procedure for outputting the
Rhythm Tone assigned to C4 from the INDIVIDUAL 5 jack
without sending it through any internal effects.
1. Select the Rhythm Set you wish to use.
2. Press [EFFECTS] so that its indicator lights.
3. Press [ ] / [ ] to choose the OUTPUT page.
4. Press [E]-[H] and select C4 in the upper left corner of the
display.
If a MIDI keyboard is connected, you can select C4 by
pressing the C4 key on the keyboard.
5. Press [ ] / [ ] to move the cursor to Output
Assign.