Filter
Top Products
65
Chapter 2 Using the XV-3080 Effects
Chapter 2
Hi Gain
Adjust the high frequency gain (amount of boost or cut).
Positive (+) settings will emphasize (boost) the high
frequency range.
Balance (Effect Balance) #
Sets the volume balance between the source sound and the
effect sound.
With a setting of D100:0W only the direct sound will be
output, and with a setting of D0:100W only the effect sound
will be output.
Pan (Output Pan)
Adjust the stereo position of the delay sound. A setting of
L64 is far left, 0 is center, and 63R is far right.
Level (Output Level)
Adjust the output level.
52:SPEAKER SIMULATOR
Speaker Simulator is an effect that simulates the speaker type
and mic settings used to record the speaker sound.
fig.2-62
Speaker Type
Select the type of speaker. The specifications of each type are
as follows. The speaker column indicates the diameter of
each speaker unit (in inches) and the number of units.
Type Cabinet SpeakerMicrophone
SMALL 1 small open-back enclosure 10 dynamic mic
SMALL 2 small open-back enclosure 10 dynamic mic
MIDDLE open back enclosure 12 x 1 dynamic mic
JC-120 open back enclosure 12 x 2 dynamic mic
BUILT IN 1 open back enclosure 12 x 2 dynamic mic
BUILT IN 2 open back enclosure 12 x 2 condenser mic
BUILT IN 3 open back enclosure 12 x 2 condenser mic
BUILT IN 4 open back enclosure 12 x 2 condenser mic
BUILT IN 5 open back enclosure 12 x 2 condenser mic
BG STACK 1 sealed enclosure 12 x 4 condenser mic
BG STACK 2 large sealed enclosure 12 x 4 condenser mic
MS STACK 1 large sealed enclosure 12 x 4 condenser mic
MS STACK 2 large sealed enclosure 12 x 4 condenser mic
METAL STACK large double stack 12 x 4 condenser mic
2-STACK large sealed enclosure 12 x 4 condenser mic
3-STACK large sealed enclosure 12 x 4 condenser mic
Mic Set (Mic Setting)
Adjust the location of the mic that is recording the sound of
the speaker. This can be adjusted in three steps, with the mic
becoming more distant in the order of 1, 2, and 3.
Mic:Dir (Mic Level:Direct Level) #
Mic:Adjust the volume of the microphone.
Dir:Adjust the volume of the direct sound.
Level (Output Level) #
Adjust the output level.
53:OVERDRIVE 2
This is an overdrive that provides heavy distortion.
fig.2-63
Drive #
Adjust the amount of distortion. The volume will change
together with the degree of distortion.
Level (Output Level)
Adjust the output level.
LowGain
Adjust the low frequency gain (amount of boost or cut).
Positive (+) settings will emphasize (boost) the low
frequency range.
Hi Gain
Adjust the high frequency gain (amount of boost or cut).
Positive (+) settings will emphasize (boost) the high
frequency range.
Amp Type (Amp Simulator Switch/Type)
Turns the Amp Simulator on/off.
And djust the type of guitar amp.
SMALL : small amp
BUILT-IN : single-unit type amp
2-STACK: large double stack amp
3-STACK: large triple stack amp
L in
R in
L out
R out
Speaker
Speaker
L in
R in
L out
R out
Pan R
Pan L
Amp
Simulator
2-Band
EQ
Overdrive