Filter
Top Products
Using talkback
Talkback / Oscillator
M7CL Owner’s Manual
14
163
3
Connect a mic to the front panel TALKBACK
jack, and turn the TALKBACK GAIN knob to
adjust the input sensitivity of the mic.
The meter in the TALKBACK IN field indicates the
input level of the mic connected to the TALKBACK
jack. If you want phantom power (+48V) to be sup-
plied to the TALKBACK jack, turn on the +48V but-
ton located in the TALKBACK IN field.
4
If you want to use an input jack other than
the TALKBACK jack as supplementary input
for talkback, follow the steps below.
1
Press the INPUT TO TALKBACK field INPUT
select button to open the INPUT PORT
SELECT popup window.
2
Press the button for the input you want to
use for talkback to turn the button indicator
on.
You can select only one input at a time.
3
Press the CLOSE button to close the popup
window.
Use the INPUT TO TALKBACK field GAIN knob
and level meter to adjust the input level of the con-
nected mic.
5
Press a button in the ASSIGN field to spec-
ify the bus(es) to which the talkback signal
will be sent (multiple selections are
allowed).
These buttons correspond to the following buses.
6
To enable talkback, press the TALKBACK
ON button to turn it on.
The TALKBACK ON button will alternately turn on/
off each time you press the button (Latch operation).
While talkback is on, the signal from the TALKBACK
jack and the selected INPUT jack will be output to the
destination bus.
• The PAD will be internally switched on or off when the HA
gain is adjusted between -14 dB and -13 dB. Keep in mind
that noise may be generated if there is a difference between
the Hot and Cold output impedance of the external device
connected to the INPUT connector when using phantom
power.
NOTE
MIX 1–16 buttons
MIX buses 1–16
MTRX 1–8 buttons
MATRIX buses 1–8
ST L, ST R buttons
STEREO bus L/R
MONO (C) button
MONO bus
•You can press the CLEAR ALL button to defeat all selections.
HINT
•You can also assign talkback on/off or an ASSIGN change to
a user-defined key. In this case, you can select either latched
operation or unlatched operation (the function will be on only
while you continue holding down the key) (
→
p. 216).
• When talkback is on, you can use the talkback dimmer to
lower the monitor levels other than talkback (
→
p. 155).
HINT