Filter
Top Products
Specifying the brightness of the touch screen, LEDs, and lamps
M7CL Owner’s Manual
237
Other functions
20
Here’s how to specify the brightness of the touch screen, top panel LEDs, and lamps connected
to the rear panel LAMP connectors.
1
In the function access area, press the
SETUP button to access the SETUP screen.
2
In the BRIGHTNESS field located in the
right of the bottom row in the SETUP
screen, press the BANK A or BANK B but-
ton.
You can save two different brightness settings in bank
A and B, and switch between them rapidly when
desired.
3
Use multifunction encoders 6–8 to set the
following parameters.
● SCREEN
Adjusts the brightness of the touch screen.
● PANEL
Adjusts the brightness of the top panel LEDs. If the
optional MBM7CL meter bridge is installed, this
will also affect the LEDs of the meter bridge.
● LAMP
Adjusts the brightness of the lamps connected to the
rear panel LAMP jacks.
4
If desired, switch between banks A/B and
make settings for the other bank in the
same way.
Now you can switch between the BANK A and BANK
B buttons of the BRIGHTNESS field to switch the
brightness of the touch screen, LCD, and lamps in a
single operation. You can also assign the BRIGHT-
NESS parameter to a user-defined key, and press that
key to switch between banks A and B.
Specifying the brightness of the touch screen, LEDs, and lamps
• If the AD8HR is connected, the brightness of the AD8HR’s
LEDs will also change.
NOTE