Filter
Top Products
Sending the signal from an input channel to the STEREO/MONO buses
M7CL Owner’s Manual
Input channel operations
5
63
This section explains how to send the signal of an input channel to the STEREO bus or MONO
bus.
The STEREO bus and MONO bus are used mainly to send signals to the main speakers. There
are two ways to send signals to the STEREO bus or MONO bus; ST/MONO mode and LCR
mode. You can select the mode individually for each channel. These modes differ in the following
ways.
This mode sends the signal from the input channel to the STEREO bus and to the MONO bus independently.
• The signal sent from the input channel to the STEREO bus and to the MONO bus can be switched on/off individually.
• The panning of the signal sent from an INPUT channel to the STEREO bus L/R is controlled by the TO ST PAN knob.
(The signal sent to the MONO bus is not affected by this knob.)
• The left/right volume balance of the signal sent from a ST IN channel to the STEREO bus is controlled by this knob.
(The signal sent to the MONO bus is not affected by this knob.)
This mode sends the signal of the input channel to a total of three buses (STEREO (L/R) and MONO (C)) together.
• The signal sent from the input channel to the STEREO bus and MONO bus will be switched on/off as a whole.
• The CSR (Center Side Ratio) knob specifies the level ratio between the signal sent from the input channel to the STE-
REO (L/R) bus and to the MONO (C) bus.
• The TO ST PAN knob / BALANCE knob specifies the level of the signal sent from the input channel to the STEREO
(L/R) bus and MONO (C) bus.
1
Make sure that an input source is con-
nected to the input channel you’re adjust-
ing, and set the phantom power supply,
gain, and phase of the head amp to obtain
the optimum input signal (→ p. 61).
2
Use the navigation keys to access the
OVERVIEW screen that includes the input
channel you want to send to the STEREO/
MONO bus.
1 STEREO/MONO field
3
In the STEREO/MONO field, press a knob to
select the channel you want to adjust, and
then press the knob once again to access
the TO STEREO/MONO popup window.
In the TO STEREO/MONO popup window you can
control the signal that is sent from the input channel to
the STEREO/MONO bus. You can view this popup
window as two types, 8ch and ALL; use the tabs below
the window to switch between them. These windows
include the following items.
[TO STEREO/MONO popup window (8 ch)]
Here you can control the on/off and pan/balance set-
tings of the signal sent from input channels to the
STEREO (L/R) bus and MONO (C) bus, in groups of
eight channels.
Sending the signal from an input channel to the STEREO/MONO buses
■ ST/MONO mode
■ LCR mode
• If you want to monitor the signal of the STEREO bus or MONO bus through headphones etc., you should press
the MONITOR button in the function access area to select “LCR” as the monitor source before you continue with
the following procedure (
→
p. 154).
HINT
1
1
3
2
4