Filter
Top Products
Using the Plug-in Boards
100
Quick Guide Using the Plug-in Board
Owner’s Manual
Using a Single Part Plug-in Board
Install any of the Single Part Plug-in Boards such as the PLG150-AN, PLG150-AP, PLG150-PF, PLG150-DX, PLG150-VL,
PLG150-DR, and PLG150-PC to the S90 ES and play the Plug-in Voice in the Voice Play mode.
See page 184.
The corresponding slot indicator at the right top of the front panel
lights. This indicates that the board has been successfully
installed.
n If the MIDI Port number here is set to “1” or “off,” the Plug-in Voice
may sound simultaneously with the internal Voice, when playing
back a Multi in the Multi/Sequence Play mode. To keep this from
happening, make sure the MIDI Port number of the Plug-in Board is
set to “2” or “3”—especially when using the Multi/Sequencer Play
mode.
To prevent a similar problem when using both a Single Part Plug-in
Board and a Multi Part Plug-in Board together, set each board to a
different MIDI Port number.
Selecting a Plug-in Voice is done in the same way as selecting a
Normal Voice (page 30) with the exception that you select one of
the PLG (Plug-in) Banks. Press the PLG button which corresponds
to the slot to which the Plug-in Board has been installed.
You’ll also need to select a Bank within the Plug-in Board. Press
the [F2] BANK button to call up the Plug-in Board Bank selection
display, then select the desired Bank.
n For details about the Bank structure of each Plug-in Board, refer to
the Owner’s Manual of each Plug-in Board. Regarding the PLGPRE
(Plug-in Preset) bank, refer to the Plug-in Voice List. Regarding the
Board Voice bank displayed as “035/000,” refer to the Voice Map/
List. The PLGUSR (Plug-in User) banks contain the Voices you
edited and stored as User Voices.
n Playing Voices of the Plug-in User banks (PLG1USR, PLG2USR,
PLG3USR) will result in no sound, if the Plug-in Board has just been
installed. These banks become available only after you edit a
Plug-in Voice and store it as a User Plug-in Voice.
1
After turning the power off, install a Single
Part Plug-in Board to the instrument.
2
Switch the S90 ES on.
3
Check the status of the installed Plug-in
Boards in the [UTILITY] → [F6] PLUG → [SF1]
STATUS display.
STRINGS
PLG 1
SLOT
1
SLOT 2
SLOT 3
BRASS
PLG 2
REED/PIPE
PLG 3
The name of the installed Plug-in Board is displayed.
VOICE
MASTER
PERFORM
MULTI/
SEQ PLAY
FILE UTILITY
SF1
F1
SF2
F2 F3 F4 F5 F6
SF3 SF4 SF5
INFORMATION
4
Set the MIDI port of the installed Plug-in Board
to “2” or “3” in the [UTILITY] → [F6] PLUG →
[SF2] MIDI display.
5
Press the [VOICE] button to enter the Voice
Play mode and select a Plug-in Voice.
6
Play the keyboard.
STRINGS
PLG 1
SLOT
1
SLOT 2
SLOT 3
BRASS
PLG 2
REED/PIPE
PLG 3