Filter
Top Products
Voice mode
Performance
mode
Multi mode Utility mode File mode Master mode
Multi Voice
mode
Sequence Play
mode
Reference
Sequence Play mode
162
Owner’s Manual
Sequence Play mode
Sequence Play mode
[MULTI/SEQ PLAY] (select Sequence Play mode)
[F1] CHAIN
Determines how the SMF files are played back. You can assign the desired SMF files and Multi settings to the desired Chain Step numbers (the playback
order). For details, see page 96.
[SF4] GET
Determines the desired slot number, partition, and directory (folder).
[SF5] DEMO
Plays the demo songs for S90 ES. For details, see page 29.
[F2] OUTPUT
These settings apply to each Chain Step number and let you specify the port number and whether or not MIDI messages are output to the internal/external
tone generator.
n The OUTPUT settings selected at the last Chain Step are applied to the Multi mode.
n You can change the settings of all channels simultaneously by changing the parameter while holding the [SF1] ALL button.
Also, you can change the settings of channels 1 - 8 or channels 9 - 16 simultaneously by changing the parameter while holding the [SF2] 1-8 button or [SF3] 9-16 button.
PORT Determines the MIDI transmission port for the corresponding track. Playback data of tracks set to off is output
without a Port designation via MIDI.
When using the internal tone generator block, the Port setting here is available for the tracks assigned to the
Plug-in Parts 1-3 (when a single Plug-in Board has been installed) and Multi Plug-in Parts 17-32 (when the
PLG100-XG has been installed). Tracks using the internal tone generator parts of this synthesizer are
automatically fixed to Port 1.
Settings: off, 1-3
n Port data can be output only through the USB terminal. No Port data is transmitted through the MIDI OUT terminal, even
if the corresponding track is set to a specific Port number.
INT SW (Internal Switch) Determines whether or not the MIDI messages of each channel are sent to the internal tone generator.
Settings: on, off
EXT SW (External Switch) Determines whether the MIDI messages of each channel are sent to the external device.
Settings: on, off
[F4] TEMPO
Determines the SMF file playback tempo. Simultaneously hold down the [F4] TEMPO button and use the Data dial or [INC/YES]/[DEC/NO] buttons to change
the value.
[F5] MEAS
Moves the current measure number. Simultaneously hold down the [F5] MEAS button and use the Data dial or [INC/YES]/[DEC/NO] buttons to change the
value.