Filter
Top Products
Using mLAN
88
Owner’s Manual
Quick Guide Connecting the Computer and Midi devices
Using mLAN
The mLAN interface is a powerful and flexible system that allows you to set up complex audio/MIDI routings through the use
of a standard IEEE 1394 connection—eliminating the need for dozens of audio and MIDI cables, as was necessary on
earlier conventional systems.
By installing the optional mLAN16E, you can directly connect the S90 ES to a computer or another mLAN device, and take
advantage of high-speed audio and MIDI data transfer between the devices with just a single IEEE 1394 cable. Special
software is also available, letting you easily change the audio and MIDI signal routing among several mLAN devices from
your computer.
Recording to computer using mLAN
In these example instructions, we'll record the audio output of the S90 ES (from playing the keyboard in the Voice mode) to
your audio sequencer on the computer.
Setting up the S90 ES
Press the [STORE] button to store the Utility mode settings.
Setting up the computer
Refer to the relevant documentation for the mLAN16E.
From the software patch bay, connect output channels 15
and 16 of the mLAN16E to any two channels of the
computer. For details, refer to the mLAN16E installation
guide and Graphic Patchbay PDF manual.
n The audio signals from playing keyboard in the Voice mode are
sent from output channels 15 and 16 of the mLAN 16E. Refer to the
next section “mLAN Audio/MIDI” signal routing.
Refer to the owner’s manual of your sequencer for details.
Recording the audio
After completing the setup described above, try recording
your keyboard performance to the computer by using the
sequencer software. For specific information, refer to the
owner’s manual of your particular sequencer.
mLAN16E
S90 ES
Audio/MIDI Interface i88X
IEEE 1394 cable
Digital Mixing Studio 01X
IEEE 1394
compatible computer
Auto Connecter,
Graphic Patchbay
Use the Auto Connector or Graphic Patchbay
software to change the audio/MIDI signal routing
among the mLAN devices.
1
Install the optional mLAN16E to the S90 ES
2
After turning the power on, set the MIDI IN/
OUT parameter to “mLAN” ([UTILITY] → [F5]
MIDI → [SF4] OTHER).
3
Enter the Voice mode by pressing the [VOICE]
button and select the desired Voice.
1
Install the necessary software such as the
mLAN driver.
2
Connect the computer to the S90 ES using an
IEEE1394 cable (page 64).
3
From the mLAN Auto Connector or Graphic
Patchbay software, connect the audio outputs
of the S90 ES to the audio inputs of the
computer.
4
Enable the mLAN input channels in the audio
device settings in the sequencer.
You can also follow this procedure to record the MIDI
data. However, you must set the MIDI connections on
the mLAN Auto Conenctor or Graphic Patchbay, and
make the appropriate MIDI device settings on your
sequenecer.