Filter
Top Products
Quick Guide Creating Your Original Program Set (Master mode)
Creating Your Original Program Set (Master mode)
94
Owner’s Manual
Assigning Control Change numbers to the Conrol sliders for each Zone
Here in the CS display of the Master Edit mode, you can set how the Control sliders will affect each Zone. This lets you
specify a separate MIDI Control Change number for each slider.
Set the parameters as shown below, corresponding to step 6 on page 92.
In the example above, the Control sliders 1 - 2 have been set to 11 (Expression), and sliders 3 - 4 for all Zones have been
set to 10 (Pan). In this way, you can use the Control sliders 1 - 2 to adjust the relative volume balance among the Zones, and
control the stereo position of each Zone with the slider 3 - 4.
PAN/SEND
PAN
ASSIGN A ASSIGN B ASSIGN
1 ASSIGN 2
REVERB CHORUS TEMPO
RELEASE
ASSIGN
MEF
TONE
ARP FX
EQ
CUTOFF RESONANCE ATTACK
SWING
MEF
1
LOW
MEF
2 MEF 3 MEF 4
GATETIME VELOCITY
UNITMULTIPLY
LOW MID
HIGH MID
HIGH
VOLUME
VOLUME 1
VOLUME
2 VOLUME 3 VOLUME 4
ZONE 1 ZONE 2 ZONE 3 ZONE 4
MASTER VOLUME
All indicators are turned off by setting the
[MASTER] → [EDIT] → [COMMON] → [F2] OTHER
→ Slider parameter to “zone.”
You can determine which Control Change numbers are used for the Control
sliders for each zone in the [MASTER] → [EDIT] → Zone selection → [F5]
CS display.