Filter
Top Products
General settings
G-70 Music Workstation
r
223
Note: The G-70 does not support the Edirol DV-7PR’s dual
stream mode.
• Press the [INIT¥SINGLE¥VALUE] field to reset the cur-
rently selected parameter to its default value.
• Press the [INIT¥ALL¥VALUES] field to reset all parame-
ters to their default values.
(4) Press [V-LINK] again to switch off this function (the
button goes dark).
Note: V-LINK messages are transmitted on MIDI channels 13
and 14.
Note: For details on clips/palettes, dissolve time, color differ-
ence signals (Cb/Cr), refer to the Edirol DV-7PR manual.
General settings
Here are several functions that apply to the G-70 as
a whole and haven’t been covered elsewhere in this
owner’s manual.
Touch Screen Beep
The G-70’s display generates a beep sound each time
you press a field. That way, you know when you have
selected parameter. You can switch this beep off if you
find it distracting.
(1) Press the [MENU] button.
The display changes to:
(2) Press the [UTILITY] field, followed by the [GLOBAL]
field.
(3) Press the [TOUCH¥SCREEN¥BEEP] field to switch this
function on or off.
(4) Press the [Back] field to return to the menu, or the
[EXIT] button to return to the main page.
Info
There may be times when you perform with a rented
G-70 (and a memory card that contains all your set-
tings), in which case it is important to quickly confirm
whether the G-70 contains the correct wave expansion
board and which system version it uses. You can also
check the remaining capacity of the internal memory
and memory card:
(1) Press the [MENU] button.
D Beam Allows you to control several effects (this
depends on the function you assign to the D
BEAM):
Vinyl RPM‰ Fade to black + playback speed
Cutting‰ Fade to back
Harp, Marimba, Guitar‰ Fade to white
Chimes‰ Lumin
Seashore‰ Sepia
LoFi‰ Color
Sweep‰ Post
Scratch‰ Color Blue
Explosion‰ Color Red
Gunshot‰ Color Violet
Tempo Up & Down + Pitch Up & Down‰
Playback speed
EXIT