Chapter 5 397
Command Definitions L-O
NSCONTROL
NSCONTROL
Controls the Network Service subsystem.
Syntax
NSCONTROL function[ ;function] ...
function may be
START=[ service[,service] ...] STOP= [ service[,service] ...] ABORT AUTOLOGON=
[ { ON OFF } ] [ { ,ALL [ ,service[,service] ] } ] LOADKEYS LOG=
[ { ON OFF } ] [ ,ALL ,RPM ,ENV ,DSDAD ,DSSERVER ,VTSERVER ] [ {
,LOW ,HIGH } ] SERVER= { servername ALL }[,minservers][,maxservers]STA
TUS= [ USERS SERVICES SERVERS SUMMARY ALL [ ,...] ] VERSION [
=MOD]
Parameters
START [=service [,service]...]... Starts Network Services that are installed on your system.
By default, all installed services are started. Optionally you may specify
one or more specific services to be started. Possible specific services
include:
LOOPBACK Enables remote users to run loopback diagnostic programs that connect to
the local node.
The following services are available if you have the NS/3000 product installed:
NFT Enables remote users to transfer files to or from the local node using the
DSCOPY command and intrinsic.
NFTL Enables local users to transfer files to or from remote nodes using the
DSCOPY command and intrinsic.
NSSTAT Enables remote users to use the NSSTATUS intrinsic and
DSLINE;SERVICES command to retrieve NS information from the local
node.
NSSTATL Enables local users to use the NSSTATUS intrinsic and
DSLINE;SERVICES command to retrieve NS information from the local
and remote nodes.
PTOP Enables remote users to create and communicate with PTOP slave
processes on the local node. The VT service must also be started. PTOP
can be used only by HPDESK.
PTOPL Enables local users to create and communicate with PTOP slave processes
on remote nodes. The VTL service must also be started. PTOPL can be
used only by HPDESK.
RFA Enables remote users to access files and data bases on the local node.
