A SERVICE OF

logo

474 Chapter 6
Command Definitions P-R
RELLOG
RELLOG
Removes a user logging identifier from the system.
Syntax
RELLOG logid
Parameters
logid The logging identifier to be removed from the system.
Operation Notes
The RELLOG command removes a user logging identifier from the system by deleting it
from the directory of logging identifiers. This command may be issued only by the user who
created the logging identifier. System supervisor (OP) or user logging (LG) capability is
required to use this command.
After RELLOG is issued, programs containing the removed logging identifier are not
allowed to access the logging system.
Use
This command may be issued from a session, job, program, or in BREAK. Pressing Break
has no effect on this command.
Example
To remove the logging identifier DATALOG from the system, enter:
RELLOG DATALOG
Related Information
Commands GETLOG
Manuals User Logging Programmer's Guide (32650-60012)