Filter
Top Products
Working with the Mixer & using effects
54
r
Linking Multi-FX type selection to the Upper part (Upper M-FX)
If you like, the DisCover 5 can automatically load the Multi-FX type that is suited for the Tone you assign to the
Upper part.
A good example of this is the selection of the
“Rotary” type for organ Tones. The status of the
Multi-FX (on or off) is also memorized and may thus
change. There may be times when you wish to
remain in control yourself. In that case, proceed as
follows:
(1) Press the [MENU] button.
The display changes to:
(2) Press the [UTILITY] field.
(3) Press the [Global] field in the upper left cor-
ner.
(4) Press the [Upper≈M-FX] field (or select it with
the [PREV] [NEXT] buttons).
(5) Use the [VALUE] dial to toggle between
“Auto” and “Manual”.
Select “Auto” if the DisCover 5 should choose a
suitable Multi-FX type for each Tone you assign
to the Upper part.
Select “Manual” if you do not want the
Multi-FX to change automatically.
(6) Press the [EXIT] button to return to the main
page.
Voice and Vocal Harmonizer part mixing
Your DisCover 5 provides three knobs ([VOICE], [HARMONY], and [EFFECTS]) that you can use without even bother-
ing about the MIXER environment. That is why there are fewer MIXER functions for this section, but a lot more
effects…
Note: For the following, it would be a good idea to set the
[EFFECTS] knob at least to “▼” to hear what you are doing.
(1) Press the [MIXER/EFFECT] button.
The display changes to:
If it doesn’t, press the [EXIT] button until you see
this page.
(2) Press the [Vocal≈Effect] field.
●
About the VOICE & HARMONY columns
For the VOICE & HARMONY columns (marked
“A” and “B” in the above illustration), you will
notice a striking analogy with the button layout
in the VOCAL HARMONIZER pad.
The part names that can appear in the VOICE
column are: TALK, SINGER, VOICE-FX, or AUTO
TUNE. → Processors: Reverb, Delay
AB