Filter
Top Products
Owner’s Manual
57
• Use the [PREV] and [NEXT] buttons to select the
parameter (knob icons) you wish to edit, and set
the desired value with the [VALUE] dial.
Parameter fields can also be selected by press-
ing them.
The three knob icons allow you to alter the
selected Reverb type.
■ Wall Type: Allows you to specify the surface of
the walls in the simulated location. This parameter
determines the “brightness” and “liveness” of the
effect. (
Carpet, Wood, Brick, Concrete, Marble)
■ Reverb Send: This parameter reflects the setting
on the Vocal Mixer page. It was provided so that you
do not need to switch pages while editing the Reverb
processor.
■ Reverb Time: Allows you to set the length (dura-
tion) of the Reverb effect if you do not agree with
the “pre-setting”.
Reverb for HARMONY EFFECTS
Except for the presets, this processor works
exactly like its VOICE namesake.
Delay for VOICE EFFECTS
• Press the field of the Delay type you wish to
use.
Note: The choice of the preset also affects the settings
of the parameters below. Always start by selecting the
type and then set the programmable parameters.
The names of these types ([Slow]~[Space]) are
probably self-explanatory. You may notice that
the Delay character changes as you select dif-
ferent types. Also note that some Delays are
stereo. [Bubble] and [Space] are “special” effects
you probably only need every so often.
• Use the [PREV] and [NEXT] buttons to select the
parameter (knob icons) you wish to edit, and set
the desired value with the [VALUE] dial.
Parameter fields can also be selected by press-
ing them.
The four knob icons allow you to alter the
selected Delay type.
■ Wall Type: This parameter determines the “bright-
ness” and “liveness” of the effect. (
Carpet, Wood,
Brick, Concrete, Marble)
■ Delay Send: This parameter reflects the setting on
the Vocal Mixer page. It was provided so that you do
not need to switch pages while editing the Delay
processor.
■ Delay Time: Allows you to set the “time lag”
between the original and the effect signal. Combined
with the “Dly Feedback” parameter, it sets the speed
of the repetitions (echoes).
■ Delay®Rev Send: This parameter sets the
amount of Delay sound that is sent to the Reverb.
Higher values mean that the Delay portion will be
more prominent in the Reverb signal. Be careful not
to overdo this effect, because it tends to blur the
sound image.
■ Dly Feedback: This parameter specifies the num-
ber of times the Delay will repeat. With a value of “0”,
the Delay will not repeat, while higher values
increase the number of repeats. With negative (–)
values, the Delay will be fed back with inverted
phase. Negative values are mainly effective with
short Delay times.
Delay for HARMONY EFFECTS
The presets on this page are different, while
there is also one more parameter you can set
(see above for the others):
■ Delay®Cho Send: Sets the amount of Delay
sound that is sent to the Chorus. Higher values mean
that the Delay portion will be more prominent in the
Chorus signal.
• Press the field of the Chorus type you wish to
use.
Delay
Chorus (HARMONY EFFECTS)