Filter
Top Products
Using Inserts 95
02R96—Owner’s Manual
Using Inserts
Input Channels, Bus Outs, Aux Sends, and the Stereo Out all feature assignable Inserts.
1 Use the SELECTED CHANNEL DISPLAY ACCESS [PHASE/INSERT] button to
select the Insert page.
The Insert page for Input Channels is shown below.
The Insert page for Bus Outs, Aux Sends, and the Stereo out is shown below.
2 Use the LAYER buttons to select Layers, and use the [SEL] buttons to select
channels.
3 Use the cursor buttons to select the parameters, and use the Parameter
wheel, INC/DEC buttons, and [ENTER] button to set them.
INSERT ON/OFF: This turns the currently selected channel’s Insert on and off.
INSERT POSITION: This determines the position of the Insert within the channel, and
can be set to pre-EQ, pre-fader, or post-fader.
INSERT OUT: This selects the destination for the Insert Out, which can be a Slot Output,
Omni Out, 2TR Digital Output, or the input to an internal effects processor. See page 204
and page 208 for Input and Output patch parameter lists. The Port ID of the currently
selected destination is displayed below the currently selected channel’s Long name in the
upper-right corner of the page. The destination port can also be selected by using the Patch
Select window (see page 57), which is accessed by pressing [ENTER] while this parameter
is selected. Insert Outs can also be patched on the Output Patch pages. See “Output Patch-
ing” on page 54 for more information.
INSERT IN: This selects the source for the Insert In, which can be an AD Input, Slot Input,
2TR Digital or Analog Input, or the output of an internal effects processor. See page 204 for
a list of Input Channel Insert In sources; page 208 for a list of Output Channel Insert In
sources. The Port ID of the currently selected source is displayed below the currently