Filter
Top Products
Automation 187
02R96—Owner’s Manual
Automation
Viewing the Automation Mode
The Automation mode setting of each channel can be viewed as follows.
1 Press either the [F3] or [F4] button.
Channel Display mode or Meter Display mode is selected.
2 Press and hold a channel’s [AUTO] button.
The channel’s Automation mode is displayed while the [AUTO] button is pressed.
For MIDI tracks, “—” appears on the display.
The Automation mode settings of all channels can be viewed as follows.
3 Press and hold the USER DEFINED [DISPLAY] (AUTO STATUS) button.
The Automation modes of all channels are displayed while the USER DEFINED [DISPLAY]
(AUTO STATUS) button is pressed.
Setting the Automation Mode
The Automation mode can be set as follows.
1 While holding down a channel’s [AUTO] button, press the USER DEFINED [3]
(WRITE), [4] (TOUCH), [5] (LATCH), [6] (READ), [7] (TRIM), or [8] (OFF) but-
ton.
If Channel Display mode or Meter Display mode is currently selected, the channel’s Auto-
mation mode is displayed while the [AUTO] button is pressed.
Grouped channels are set together.
Pro Tools Display [AUTO] Button Indicators
Auto write
Wrt
Flashing red (Record Ready)
Red (Recording)
Auto touch
Tch
Auto latch
Ltch
Auto read
Read Green
Auto off
Off Off