Filter
Top Products
36 Chapter 3—Operating Basics
02R96—Owner’s Manual
Selecting Encoder Modes
The exact function of each Encoder depends on the selected Layer and Encoder
mode. There are two preset Encoder modes, Pan and Aux, and two assignable
modes, for which you can choose from over 40 parameters.
1 Select a Layer, as explained in page 33.
2 Use the ENCODER MODE buttons to select an Encoder mode.
[PAN]: Encoders function as Pan controls.
[AUX]: Encoders control Aux Send levels, depending on the selected Layer.
[ASSIGN 1/2]: Encoders control the parameters assigned to the ASSIGN buttons. See
“Assigning Parameters to the ENCODER MODE Assign Buttons” on page 37 for more
information.
The indicator of the currently selected ENCODER MODE button lights up.
The following table shows the exact Encoder functions for each Layer and Encoder mode.
Layer
Encoder
Mode
Encoder
1–8 9–16 17–24
1-24
Pan
Input Channels 1–24 pan
Aux
Input Channels 1–24 Aux Send level
Assign 1/2
Input Channels 1–24 assigned parameter
25–48
Pan
Input Channels 25–48 pan
Aux
Input Channels 25–48 Aux Send level
Assign 1/2
Input Channels 25–48 assigned parameter
Master
Pan
Input Channels 49–56
pan
No operation
Aux
Input Channels 49–56
Aux Send level
No operation
Assign 1/2
Input Channels 49–56
assigned parameter
Aux Sends 1–8
assigned parameter
Bus Outs 1–8 assigned
parameter
Remote
Pan
Operation depends on the selected target. See “About the Remote Layer”
on page 189 for more information.
Aux
Assign 1/2
AUXPAN
ASSIGN 2ASSIGN1
ENCODER MODE
DISPLAY