246 Appendix A: Parameter Lists
02R96—Owner’s Manual
AUTO PAN 5.1
Six input, six output autopanner for 5.1 surround. You can reset to the pan position speci-
fied by the OFFSET parameter by pressing the RESET button.
CHORUS 5.1
Six input, six output chorus for 5.1 surround.
Parameter Range Description
SOURCE
OFF, HOLD, INPUT,
MIDI
When set to OFF, the TRIGGER button is used to start auto-
pan. When set to HOLD, autopan runs continuously. When
set to INPUT, the input signal triggers autopan. When set to
MIDI, a MIDI Note On message can be used to trigger auto-
pan.
TRIG. LVL
–60 to 0 dB
Input trigger level (i.e., the signal level required to trigger
panning when SOURCE set to INPUT)
TIME
0.1 s–10.0 s The time after which autopan starts once it’s been triggered
SPEED
0.05 Hz–40.00 Hz Autopan speed
DIR.
Turn L, Turn R Autopan direction
OFFSET
–180 to +180 degrees Pan offset
HPF
THRU, 21.2 Hz–8.00
kHz
High-pass filter cutoff frequency
LPF
50.0 Hz–16.0 kHz,
THRU
Low-pass filter cutoff frequency
Parameter Range Description
FREQ.
0.05–40.00 Hz Modulation speed
AM DEPTH
0–100% Amplitude modulation depth
PM DEPTH
0–100% Pitch modulation depth
MOD. DLY
0.0–400.0 ms Modulation delay time
WAVE
Sine, Tri Modulation waveform
HPF
THRU, 21.2 Hz–8.00
kHz
High-pass filter cutoff frequency
LPF
50.0 Hz–16.0 kHz,
THRU
Low-pass filter cutoff frequency
SYNC
OFF/ON Tempo parameter sync on/off
NOTE
1
1.
Used in conjunction with TEMPO to determine FREQ.
