Filter
Top Products
188 Chapter 18—Pro Tools Remote Layer
02R96—Owner’s Manual
Trim Mode
Trim mode can be set as follows.
1 While holding down a channel’s [AUTO] button, press the USER DEFINED
KEYS [7] (TRIM) button.
If channel Display mode [F3] or Meter Display mode [F4] is currently selected, the chan-
nel’s Automation mode is displayed while its [AUTO] button is pressed.
You can display the Automation mode settings of all channels by pressing and holding the
USER DEFINED KEYS [DISPLAY] (AUTO STATUS) button.
Grouped channels are set together.
Arming Parameters for Automation
Parameters can be selected for automation recording as follows.
1 Use the following USER DEFINED KEYS to arm parameters.
The button indicators for armed parameters light up.
Pro Tools Display [AUTO] Button Indicators
Auto trim/write
TWrt
Flashing red/orange (Record Ready)
Orange (Recording)
Auto trim/touch
TTch
Auto trim/latch
TLch
Auto trim/read
TRd Flashing green/orange
USER DEFINED KEYS Pro Tools
[11] (FADER) Volume
[12] (MUTE) Mute
[13] (PAN) Pan
[14] (SEND) Send level
[15] (SEND MUTE) Send mute
[16] (PLUG-IN) Plug-in