Filter
Top Products
88 Captured curves
Setting up captured curves
Models SE and DL
Setting up captured curves
Setting up Captured Curves Settings and measurement settings
1. From the start screen, select either 1/1 octave or 1/3 octave for the
measurement type. (Repeatedly press first softkey.)
Figure 6-8: Selecting measurement type for curves
2.
Next, select the measurement type, by selecting View Session (use
Up/Down Arrow to select) and press Enter . Select the appropriate
meter 1 settings (using the softkeys) and set the response time, weighting,
and measurement type. (See Figure 3-4, page 27 for an example).
NOTE: It is recommended to set Meter 1 to Slow response, Z-weighting, and
measurement to Leq.
3. Press On/Off/Esc to return to the start screen.
4. Select Setup (use up/down arrows to highlight) and press Enter .
5. Select Options menu (use up/down arrows to highlight)and press Enter .
6. Select Curves menu (use up/down arrows to highlight) and press Enter .
7. For the Mode, press Enter repeatedly to select either Survey or
Evaluation setting. (Please see explanation below).
• Survey Mode: dynamically evaluates the noise and reports the
appropriate noise curve. Typically used if you wish to take multiple curve
samples to evaluate and re-evaluate noise in a room/zone.
Selecting Measurement type
Press first softkey until 1/1 or 1/3
is selected