Filter
Top Products
44 Setting up auto-run
Level-triggered auto-on setting
Models SE and DL
Level-triggered auto-on setting
The level-triggered screen contains meter 1 parameters which include a
Filter mode, Frequency level, “Level On” and “Level Off” modes, and a
specification for either run/stop or run/pause modes.
Viewing or changing level-triggered mode
1. From the start screen, press Up/Down to highlight Setup and
press Enter .
2. Select Auto-Run by using Up/Down to highlight and press
Enter to select.
3. In the Auto-Run screen, repeatedly press Enter until Level-
Triggered appears.
4. Press the Down arrow to select View/Set Parameters and press
Enter . The Level-Triggered Auto-Run screen will appear.
• See Table 4-1 below for explanation of settings.
Figure 4-7: Level-Triggered screen
Level-
Triggered
Explanation of Settings
A. Mode
The mode, or Filtered Mode, can be set to Level On/Off and Windowed
settings.
• In Level On/Off mode, the unit starts a run when the source level
exceeds the specified criteria and stops/pauses when level falls below the
off criteria. The on criteria is met and either pause or stop a run when the
off criteria is met.
• In Windowed mode, the unit starts a run when the selected criteria falls
outside the defined window. This is intended primarily for curves but can
also be used with broadband or individual filter measurements.
\setup\LVL-TRG-RUN
MODE LEVEL ON/OFF
ACTION RUN/PSE
TRIGGER RUN PAUSE
SOURCE METER 1 METER 2
LEVEL 90.0 OFF
Mode: to enable a
filter mode, select
Level On/Off or
Windowed
Action: Run/Pause
or Run/Stop
Source/Level:
Select one of the 5
features and then
set an appropriate
Level.
A
B
C
D