Filter
Top Products
89 Captured curves
Setting up captured curves
Models SE and DL
• Evaluation Mode: evaluates the noise levels against specific criterion.
This is primarily used when you are capturing one to four different
curves. With this option, you assign a Capture name (Cap-1, Cap-2,
Cap-3, Cap-4) in the setup menu and then run a captured curve study.
To assign a new captured curve name, you return to the Options menu,
select a name and then return back to view session mode and run your
study.
NOTE: Whether you choose Survey or Evaluation mode, the captured
curved results will report the same data. The survey mode is
recommended for Captured Curves since it is slightly easier to use in the
field.
8. Depending on your selection in step 4, refer to the following:
• If Survey Mode was selected, please see step 6.
• If Evaluation mode was selected, press Up/Down to highlight
Criterion. Repeatedly press Enter to select Cap-1, Cap-2, Cap-3,
Cap-4.
9. Press On/Off/Esc twice to return to the start screen.
Figure 6-9: Captured Curves and Survey mode
Mode
Press Enter repeatedly to
toggle between Survey and
Evaluation modes.
Curves screen
Type
“Captured (CAP)”
automatically appears when
you select Survey as the type.