Filter
Top Products
58 Overview of running a session/study
Meter 1/Meter 2 explained
Models SE and DL
Overview of running a session/study
The list below is a brief overview of the steps for running a study.
Quick Help List
1. Turn the SoundPro on and check your battery power. (See Chapter 1).
2. Format the card or delete session files from the SoundPro.
o Formatting the card will clear out all of data before your study begins.
Choosing to select specific session files and delete will also clean up
the instrument’s sessions. (See Chapter 7).
3. Adjust your settings to fit the specifications of your sound study. (See
Chapter 4 and Chapter 6)
4. Set the measurement range (Chapter 5)
5. Calibrate the SoundPro (Chapter 5)
6. Position the SoundPro in the field and connect appropriate external
devices if applicable.
7. Press the Run/Pause key to start the session. (Chapter 5)
8. To Pause the session (if needed) press the Run/Pause key. (Chapter 5)
9. When you are ready to end your session/study, press the Stop key.
NOTE: You must be in pause mode to stop a session/study. (Chapter 5)
10. Review your measurement results on the SoundPro display (Chapter 5).
Or view results in QSP-II, see Communicating in Chapter 8.