Filter
Top Products
38 Auto-Run
Date setting
Models SE and DL
Auto-Run
SoundPro SE/DL has four automatic run modes which include: Date auto-
start with duration, Day of the Week auto-start with duration, Timed Run
(duration only setting), and Level Triggered Runs (or Level auto-start runs).
Setting up auto-run
All Auto-Run setups begin in the Auto-Run screen. The Auto-Run screen
shows the current status of the Auto-Run feature. The following features are
available: Disabled, Timed Run, DOW (day of week), Date, and Level-
Triggered settings.
Date setting
A Date mode run wakes up the instrument from a powered down condition,
runs the study, saves it, then powers down again and is only executable
once. The parameters are selectable by specified dates and times with up to
four programmable individual setups.
A plus sign preceding a number (i.e., +1) indicates if one of the four settings
is enabled (or activated) where as a negative sign (i.e. -4) represents a
disabled (or deactivated) setting.
Setting up or changing auto-run with date parameter
1. From the start screen, press Up/Down to highlight Setup and press
Enter .
2. Select Auto-Run by using Up/Down to highlight and press Enter
to select.
3. In the Auto-Run screen, repeatedly press Enter until Date appears.
Figure 4-1: Auto-Run with Date selected
4. To select View/Set Parameters, press the Down arrow to highlight and
press Enter .
Date setting
View/Set Parameters – when
selected a new menu appears