Filter
Top Products
50 Digital outputs/Triggering
Tracking runs
Models SE and DL
Digital outputs/Triggering
All digital output signals (also referred to as “Triggering”) appear on pins of
the Auxiliary Port (“Auxiliary port” on page 7). Manage these digital outputs in
the Ext-Trigger screen.
Tracking runs
The instrument can be configured to use a digital output to signal the start or
end of a run.
Enabling or Disabling run/pause digital outputs/triggers
1. From the start screen, press Up/Down to highlight Setup and
press Enter .
2. Select Digital-Out by using Up/Down to highlight and press
Enter to select.
3. Press to select Output 1.
4. Press to enable (Run/Pse) or disable (Off) run tracking.
5. If you enabled and want to reverse the trigger logic, continue below.
Otherwise, skip to step 9.
6. Press to select Logic 123, then press to enter the first data
field. The second data field is for Output 1.
7. Press to select the second data field, then press to toggle the
logic state. The displayed logic state is for a running study.
8. Press to exit the Logic 123 data field.
9. If finished, press to exit the screen.
Figure 4-13: Digital-Out screen
OUTPUT 1
Select Run/Pause to enable