Filter
Top Products
48 Locking setup or run mode
Setting secure run or secure setup (locking)
Models SE and DL
3. (Skip this step if securing setup and see step 4.) To set Secure Run
Mode, press Enter and “0000” will appear.
NOTE: if you want to set the code as “0000,” press Enter
repeatedly until “enabled” appears. This will be the unlock code.
Figure 4-10: Adding code for secure/lock screen
• To select a numeric code, press Up/Down arrows to select a
number, press Enter to toggle between the fields.
• Press Enter to Enable.
• Press On/Off/Esc key to return to the Start screen. When you are
ready to run a session, press the Run/Pause key and the Secure
Run Mode prompt will appear. (See “Disabling secure run or secure
setup” below for details on stopping the run.)
Figure 4-11: Secure/lock run prompt
•
Selected value is shaded
• Enter code by pressing up/down
arrows to change value
• Press enter to move to each field
To unlock/unsecure
Press lock softkey and
then enter in code.