Filter
Top Products
71 Measurement screens
Tabulation screens
Models SE and DL
Tabulation screens
The Tabulation screen shows measurements for two broadband
measurements and for all the bands for the selected analysis type. For
octave analysis, all bands are visible in a single tabulation screen. When
viewing third-octave analysis, however, it takes three screens to display the
tabulated measurements for all bands. Press to cycle through them.
Figure 5-12: Tabulation screen for octave filtering
1/1 and 1/3 octave analysis measurement results
• Measurements and meters - All tabulated values in this screen are for
the displayed measurement and the selected meter.
• Broadband measurements - The first measurement in the screen is a
broadband measurement for the selected meter. Following that
measurement, is the number of the selected meter (Meter 1 in this
example).
• Filtered measurements - After the broadband measurement, all other
measurements given in the display are for Meter 1 in each of the
frequency bands according to the type of analysis performed. For each
band, the center frequency of the band is given and the measurement in
that band is given at the right of the band’s identification.
Tabulation view
Shows the average SPL on Meter 1
only.
• Only available if a filter option and
1/1 or 1/3 octave band is enabled
on your meter.