Filter
Top Products
136
Installing & Setting Up the Driver (Windows)
Installing the OS-standard driver
■ Windows XP/2000 users
1.
With the GS-10 disconnected, start up Windows.
Disconnect all USB cables except for a USB keyboard and USB mouse (if used).
2.
Exit all currently running software (applications).
Also close any open windows. If you are using virus checking or similar software, be sure to exit it
as well.
3.
Before connecting the USB cable, switch the GS-10’s driver mode to “Standard.”
For instructions on switching the GS-10’s driver modes, refer to “Switching the Driver Mode” (p. 80).
4.
With the power switch turned OFF, use the USB cable to connect the GS-10 to
your computer.
5.
Make sure that the GS-10’s OUTPUT LEVEL is set to the lowest setting, then
switch ON the POWER switch.
The GS-10 will be detected automatically, and the driver will be installed.
6.
When installation is complete, restart Windows.
→ Next, you need to make the driver settings (p. 141).
The installation procedure will differ depending on your system.
Please proceed to one of the following sections, depending on the system you use.
• Windows XP/2000 users.............. (p. 136)
• Windows Me users ....................... (p. 137)
• Windows 98 users........................ (p. 138)
Turn on power to your various
devices in the order specified.
By turning on devices in the
wrong order, you risk causing
malfunction and/or damage to
other devices.
This unit is equipped with a
protection circuit. A brief
interval (a few seconds) after
power up is required before
the unit will operate normally.