Filter
Top Products
76
Chapter 8 Using the GS-10 with External MIDI Devices Connected
Controlling the Device Remotely
Making the Connections
Make the connections as shown below.
fig.08-280
* For more on the operation of the connected device, refer to the
owner’s manual for the device you are using.
Setting
1. Follow the instructions in “Setting the Messages Used
for Controlling Devices” (p. 75) to set the messages that
are to be used for remote control.
2. Press [SYSTEM] a number of times, then press
PARAMETER [ ] [ ] so that “SYS:CTL1 Func”
(or “SYS:CTL2 Func”) is displayed.
fig.08-290d
* If connecting only one foot switch, set the GS-10 so that
“SYS:CTL1 Func” is indicated; if connecting two foot
switches, set the GS-10 so that “SYS:CTL1 Func” or
“SYS:CTL2 Func” is indicated for the corresponding foot
switch.
3. Rotate the PATCH/VALUE dial to select “Remote Strt/
Stop.”
* For more on “SYS:CTL1 Func” (or “SYS:CTL2 Func”), refer
to p. 59.
4. Press [EXIT] to return to the Play screen.
Each time the foot switch is pressed, it alternately sends
Start and Stop.
MIDI OUT
MIDI IN
EXP PEDAL
/ CTL 1,2
With the GS-10, you can control external MIDI devices
by combining [EXIT] and DIRECT PATCH [1]–[4].
fig.08-300
The Reset, Stop, Play, and Rec functions are assigned to
DIRECT PATCH [1]–[4]. When you press these buttons
while holding down [EXIT], the messages corresponding
to the MIDI: Remote Ctrl setting are transmitted.
When MIDI: Remote Ctrl is set to Standard
MIDI System messages are transmitted.
* Neither FA nor FC can be transmitted consecutively.
When MIDI: Remote Ctrl is set to Advanced
Some computer applications allow recording and
playback functions such as Start and Stop to be assigned
to specified MIDI messages.
When set to this setting, Note messages used in
assigning functions are transmitted in addition to the
Standard messages.
Use the software to set the operations to be performed by
means of these Note messages.
* Neither FA nor FC can be transmitted consecutively.
* Note messages are transmitted over the selected
transmission channel (p. 69).
When set to MMC
MIDI Machine Control is transmitted.
Reset No function
Stop FC
Play FA
Rec No function
Reset 90 00 01 90 05 01 90 05 00 90 00 00
Stop 90 00 01 90 02 01 90 02 00 90 00 00 FC
Play 90 00 01 90 04 01 90 04 00 90 00 00 FA
Rec 90 00 01 90 07 01 90 07 00 90 00 00
Reset F0 7F 7F 06 44 06 01 00 00 00 00 00 F7
Stop F0 7F 7F 06 01 F7
Play F0 7F 7F 06 02 F7
Rec F0 7F 7F 06 06 F7
Reset Play RecStop