Filter
Top Products
72
Chapter 8 Using the GS-10 with External MIDI Devices Connected
fig.08-180d
When the transmission is completed, the screen prior to
transmission returns to the display.
4. Press [EXIT] to return to the Play screen.
Receiving Data from an External
MIDI Device (Bulk Load)
Making the Connections
When Receiving Data Saved on a MIDI Sequencer
Connect as shown below. Set the GS-10’s Device ID to the
same number that was used when the data was transmitted
to the MIDI sequencer.
fig.08-190
* For instructions on operating the sequencer, refer to the
owner’s manual for the sequencer you are using.
Receiving
1. Press [SYSTEM], then press PARAMETER [ ]
[] so that “MIDI:Bulk Load” is displayed.
fig.08-200d
2. Transmit the data from the external MIDI device.
The following appears in the display when the GS-10
receives the data.
fig.08-210d
The following appears in the display when the GS-10
finishes receiving the data.
fig.08-220d
At this stage, even more data can be received.
3. Press [EXIT] to quit Bulk Load.
After you press [EXIT], the Play screen returns to the
display.
MIDI IN
MIDI OUT