Filter
Top Products
157
Installing & Setting Up the Driver (Macintosh)
Installing the OS-standard driver
■ Mac OS 9/8 users
1.
With the GS-10 disconnected, start up Mac OS.
2.
Exit all currently running software (applications).
If you are using a virus checker or similar software, be sure to exit it as well.
3.
After starting up Mac OS, select Apple System Profiler from the Apple menu.
The “Apple System Profiler” dialog box will appear.
fig.11-620
4.
Click the “Devices and Volumes” tab.
5.
Before connecting the USB cable, switch the GS-10’s driver mode to “Standard.”
For instructions on switching the GS-10’s driver modes, refer to “Switching the Driver Mode” (p. 80).
6.
With the power switch turned OFF, use the USB cable to connect the GS-10 to
your computer.
7.
Make sure that the GS-10’s OUTPUT LEVEL is set to the lowest setting, then
switch ON the POWER switch.
Wait for approximately five seconds.
While you are waiting, the screen display will not change, but the GS-10 is being detected. Do not
touch the mouse or keyboard.
8.
In order to check that detection has been completed, once again go to “Apple
System Profiler”, and select “Update all information” from the Commands menu.
In the USB area, three audio devices will be displayed.
If these are displayed correctly, driver installation has succeeded.
fig.11-630
9.
In the File menu, click Quit to close “Apple System Profiler.”
If they are not displayed correctly, disconnect the GS-10, wait for about ten seconds, and then repeat
the procedure from step 2.
The installation procedure will differ depending on your system.
Please proceed to one of the following sections, depending on the system you use.
• Mac OS 9/8 users......................... (p. 157)
• Mac OS X users ............................ (p. 160)
Turn on power to your various
devices in the order specified.
By turning on devices in the
wrong order, you risk causing
malfunction and/or damage to
other devices.
This unit is equipped with a
protection circuit. A brief
interval (a few seconds) after
power up is required before
the unit will operate normally.