Filter
Top Products
16
Chapter 1 Playing Sounds
Setting Output Device
(Amps) (OUTPUT SELECT)
Select the type of output device connected to the OUTPUT
jack or GUITAR AMP OUT jack.
fig.01-061
1. Press [SYSTEM], causing the indicator to light.
The Output Select settings screen appears.
fig.01-070d
2. Turn the PATCH/VALUE dial to select the type of
device connected to the OUTPUT jack or GUITAR
AMP OUT jack.
Line/Phones
Set this when connecting the OUTPUT jack to an audio
set or when connecting a recorder for recording.
Use this setting also when using the GS-10’s speakers or
headphones.
Combo AMP
Use this setting when connecting to the guitar input of a
combo amp (where the amp and speaker or speakers are
combined in a single unit).
Stack AMP
Use this setting when connecting to the guitar input of a
stack-type guitar amp (where the amp and speaker or
speakers are separated).
Combo Return
Use this setting when connecting to RETURN with a
combo amp.
Stack Return
Use this setting when connecting to RETURN of a stack
amp or rack mounted power amp.
3. Press [EXIT] to return to the Play screen.
* Set OUTPUT SELECT as shown below, when the PREAMP/
SPEAKER type (p. 29) is set to CONCERT 810, SESSION,
BASS 360, T.E., B-MAN, FLIP TOP, Bass Clean, Bass
Crunch, Bass HiGain, or Mic Preamp.
When connecting to an audio amp or similar equipment:
Line/Phones
When connecting to a guitar amp:
Combo Amp or Combo Return
When connecting to a bass amp:
Stack Amp or Stack Return
To derive the maximum performance from the GS-10, be
sure to make the correct setting for OUTPUT SELECT,
the one that’s most suitable for your setup.
13
2
Guitar Tuning
You can use the GS-10’s built-in “tuner function” to tune
your guitar.
For instructions on using this function, refer to “Tuning
the Guitar” (p. 64).