Filter
Top Products
60
Chapter 6 Setting the External Pedal Functions
Setting the External Pedal Function
for Individual Patches (Assign)
There are two ways to set the assignments, “Quick
Settings,” which allows you to use [QUICK FX] to complete
the settings quickly and easily, and “Manual Settings,”
where each parameter is set one at a time.
Quick Settings
When you use [QUICK FX] to select prepared settings (Preset
settings), the relevant parameters are then instantly set to
their optimal values. This lets you finish making the settings
simply, instead of setting each individual parameter
separately.
fig.06-010
1. Press [ASSIGN].
2. Press PARAMETER [ ] [ ] to select one of the
Assigns from Assign 1–8.
3. Press [ASSIGN] to set the selected Assign to “On.”
Each time [ASSIGN] is pressed it alternately switches
this on and off. “ASSIGN” flashes in the display when
the Assign is switched off.
* Always set any Assign to “Off” when it is not being used.
4. Press [QUICK FX].
The Preset settings selection screen appears in the
display.
fig.06-011d
* The following appears when the Quick Settings are changed
through editing of parameters immediately after the patches
are changed.
fig.06-012d
5. Turn the PATCH/VALUE dial to select the Preset
settings.
6. To use the Quick Settings with other Assigns, repeat
Steps 2–5.
Even when using this procedure, the settings selected in
Step 5 are maintained as is and carried over to the Quick
Settings for the next effect.
7. To save the settings, use the Write procedure (p. 25).
Press [EXIT] to return to the Play screen.
Preset Settings
* The foot switch function is enabled for the foot switch
connected to CTL 1.
1,3 4
52
P01 PEDAL WAH
The expression pedal functions as
a wah pedal.
P02 PEDAL BEND
The expression pedal is used for
pedal bend.
P03 FOOT VOLUME
The expression pedal functions as
a volume pedal.
P04 COMP ON/OFF
The compressor is switched on
and off with the foot switch.
P05 OD/DS ON/OFF
The overdrive/distortion is
switched on and off with the foot
switch.
P06 DELAY ON/OFF
The delay is switched on and off
with the foot switch.
P07
CHRUS ON/OFF
The chorus is switched on and off
with the foot switch.
P08 FX-1 ON/OFF
FX-1 is switched on and off with
the foot switch.
P09 FX-2 ON/OFF
FX-2 is switched on and off with
the foot switch.
P10 DLY TIME TAP
The foot switch is used for tap in-
put of the delay time.
P11 MSTR BPM TAP
The foot switch is used for tap in-
put of the Master BPM.
P12 CH SEL INC
The foot switch is used for switch-
ing the preamp/speaker channel
select (A → B → C → A → ...).