Filter
Top Products
39
Chapter 4 Introduction to Effects and Parameters
Section 4
ENH (Enhancer)
By adding sounds which are out-of-phase with the direct
sound, this effect enhances the definition of the sound, and
pushes it to the forefront.
Parameter Value
Sens 0–100
Freq 800 Hz–10.0 kHz
Mix Level 0–100
Sens (Sensitivity)
Adjusts the manner in which the enhancer will be applied
relative to the input signals.
Freq (Frequency)
Adjusts the frequency at which the enhancer effect will begin
to be applied. The effect will be made apparent in the
frequencies above the frequency set here.
Mix Level
Adjusts the amount of phase-shifted sound of the range set
by “Frequency” that is to be mixed with the input.
SG (Slow Gear)
This produces a volume-swell effect (“violin-like” sound).
Parameter Value
Sens 0–100
Rise Time 0–100
Sens (Sensitivity)
This adjusts the sensitivity of the slow gear. When it is set to
a lower value, the effect of the slow gear can be obtained only
with a stronger picking, while no effect is obtained with a
weaker picking. When the value is set higher, the effect is
obtained even with a weak picking.
Rise Time
This adjusts the time needed for the volume to reach its
maximum from the moment you begin picking.
TR (Tremolo)
Tremolo is an effect that creates a cyclic change in volume.
Parameter Value
Wave Shape 0–100
Rate 0–100, BPM –BPM
Depth 0–100
Wave Shape
This adjusts changes in volume level.
Rate
Adjusts the frequency (speed) of the change.
* When set to BPM, the value of each parameter will be set
according to the value of the Master BPM (p. 54) specified for
each patch. This makes it easier to achieve effect sound settings
that match the tempo of the song (synchronizing the cycle to
one-half or one-fourth of the BPM when the set cycle rate is
increased).
When setting to BPM, press PARAMETER [ ] to display
the Master BPM settings screen.
Depth
Adjusts the depth of the effect.