Filter
Top Products
46
Chapter 4 Introduction to Effects and Parameters
Xover f (Crossover Frequency)
This parameter sets the frequency at which the frequency
components of the direct sound are divided into bass and
treble bands.
Lo Rate (Low Rate)
Adjust the speed of the chorus effect for the low frequency
range.
* When set to BPM, the value of each parameter will be set
according to the value of the Master BPM (p. 54) specified for
each patch. This makes it easier to achieve effect sound settings
that match the tempo of the song (synchronizing the cycle to
one-half or one-fourth of the BPM when the set cycle rate is
increased).
When setting to BPM, press PARAMETER [ ] to display
the Master BPM settings screen.
Lo Depth (Low Depth)
Adjust the depth of the chorus effect for the low frequency
range. If you wish to use this as a doubling effect, use a
setting of “0.”
Lo PreDly (Low Pre Delay)
Adjust the time from when the low frequency range direct
sound is output until the effect sound is output. Extending
the pre-delay will produce the sensation of multiple sounds
(doubling effect).
Lo Level (Low Level)
Adjust the volume of the low frequency range.
Hi Rate (High Rate)
Adjust the speed of the chorus effect for the high frequency
range.
* When set to BPM, the value of each parameter will be set
according to the value of the Master BPM (p. 54) specified for
each patch. This makes it easier to achieve effect sound settings
that match the tempo of the song (synchronizing the cycle to
one-half or one-fourth of the BPM when the set cycle rate is
increased).
When setting to BPM, press PARAMETER [ ] to display
the Master BPM settings screen.
Hi Depth (High Depth)
Adjust the depth of the chorus effect for the high frequency
range. If you wish to use this as a doubling effect, use a
setting of “0.”
Hi PreDly (High Pre Delay)
Adjust the time from when the high frequency range direct
sound is output until the effect sound is output. Extending
the pre-delay will produce the sensation of multiple sounds
(doubling effect).
Hi Level (High Level)
Adjust the volume of the high frequency range.
PAN
With the volume level of the left and right sides alternately
changing, when playing sound in stereo, you can get an
effect that makes the guitar sound appear to fly back and
forth between the speakers.
Parameter Value
Wave Shape 0–100
Rate 0–100, BPM –BPM
Depth 0–100
Wave Shape
This adjusts changes in volume level.
Rate
Adjusts the frequency (speed) of the change.
* When set to BPM, the value of each parameter will be set
according to the value of the Master BPM (p. 54) specified for
each patch. This makes it easier to achieve effect sound settings
that match the tempo of the song (synchronizing the cycle to
one-half or one-fourth of the BPM when the set cycle rate is
increased).
When setting to BPM, press PARAMETER [ ] to display
the Master BPM settings screen.
Depth
Adjusts the depth of the effect.
VB (Vibrato)
This effect creates vibrato by slightly modulating the pitch.
Parameter Value
Rate 0–100, BPM –BPM
Depth 0–100
Trigger Off, On
Rise Time 0–100
Rate
This adjusts the rate of the vibrato.
* When set to BPM, the value of each parameter will be set
according to the value of the Master BPM (p. 54) specified for
each patch. This makes it easier to achieve effect sound settings
that match the tempo of the song (synchronizing the cycle to
one-half or one-fourth of the BPM when the set cycle rate is
increased).
When setting to BPM, press PARAMETER [ ] to display
the Master BPM settings screen.