Filter
Top Products
73
Chapter 8 Using the GS-10 with External MIDI Devices Connected
Section 8
Setting the Program Change Map
When switching patches using Program Change messages
transmitted by an external MIDI device, you can freely set
the correspondence between Program Change messages
received by the GS-10 and the patches to be switched to in
the “Program Change Map.”
Initial Program Change Map Settings
The Program Change Map set at the factory is shown below.
fig.08-230
1. Press [SYSTEM], then press PARAMETER [ ]
[] so that “MIDI:Map Select” is displayed.
fig.08-240d
2. Rotate the PATCH/VALUE dial to select “Program.”
* You cannot set the Program Change Map when “Fix” is
selected (it is not displayed).
* See below for more on “MID Map Select.”
3. Press PARAMETER [ ] until “MIDI:Program Map”
appears in the display.
fig.08-250d
4. Press PARAMETER [ ] [ ] to move the cursor,
and rotate the PATCH/VALUE dial to set the received
Program number and the corresponding patch number.
* Use this same procedure to select Bank Select Numbers.
* When using only Program Change messages to make program
changes, without using Bank Select messages, set the Program
number (1-128) when the Bank Select number is “0.”
5. Repeat Step 4 as needed, setting patch numbers to their
corresponding Program numbers, until the Program
Change Map is completed.
6. Press [EXIT] to return to the Play screen.
Program Change
Patch Number
Bank
Select
Program
Number
0
1 U001
2 U002
3 U003
: :
: :
98 U098
99 U099
100 U100
101 U100
102 U100
: :
128 U100
1
1 P101
2 P102
3 P103
: :
: :
98 P198
99 P199
100 P200
101 P200
102 P200
: :
128 P200
16
1,423
Bank Select
Number
Program
Number
Patch
Number