Filter
Top Products
27
Chapter 3 Saving the Tones You Have Created
Section 3
Registering Your Favorite
Patches (DIRECT PATCH)
You can register preferred patches to DIRECT PATCH [1]–[4]
and then press these buttons to call up the corresponding
patches directly.
fig.03-070
1. Press [SYSTEM] a number of times until “DIRECT
PATCH” is displayed.
fig.03-080d
2. Press PARAMETER [ ] [ ] to select the number
of the DIRECT PATCH button to which you want to
register the patch.
3. Use the PATCH/VALUE dial to select the patch you
want to register.
4. Press [EXIT] to return to the Play screen.
Copying the PREAMP/SPEAKER
Settings to Another Channel
You can take the PREAMP/SPEAKER settings for one
channel and copy them to another channel.
fig.03-090
1. Select the copy-source channel.
2. Press [WRITE].
3. Press CHANNEL SELECT [A]–[C] to select the copy-
destination channel.
The channel copy screen appears in the display.
* If you press the button for the same channel as the copy source,
a channel other than the copy-source channel is selected for the
copy destination.
fig.03-100d
* To change the copy-source or copy-destination channel, press
PARAMETER [ ] [ ] to move the cursor to the copy-
source or copy-destination channel, then press CHANNEL
SELECT [A]–[C].
You can alternatively rotate the PATCH/VALUE dial to
change the channel at the cursor position.
* When the copy-source channel is changed, the tone is changed
as well.
* To cancel the copy, press [EXIT]. The Play screen returns to
the display.
4. Press [WRITE].
The settings are copied.
* If you want to keep a tone for which you have made settings,
use the “Write procedure” (p. 25) to save it to a User patch.
4 1
32
You can also register patches by selecting the patch in
the Play screen, then pressing one of the
DIRECT PATCH
[1]–[4] buttons after pressing the [WRITE] button. In this
case, the patch appearing in the display is registered.
* When a patch is registered using this method, the current
settings are also saved along with the patch when it’s
registered. If you want to register only the patch, use the
regular registration method.
2,4
1,3
Copy-destination channel
Copy-source channel