Filter
Top Products
33
Chapter 4 Introduction to Effects and Parameters
Section 4
DELAY
This effect adds delayed sound to the direct sound, giving
more body to the sound or creating special effects.
Parameter Value
On/Off Off, On
Type Single, Pan, Stereo
DlyTime 0 ms–1800 ms,
BPM –BPM
Delay Time.F 0 msec–20 msec
Tap Time 0%–100% (Type = Pan)
Feedback 0–100
High Cut 700 Hz–11.0 kHz, Flat
Effect Level 0–120
On/Off (Effect On/Off)
Turns the DELAY Effect on/off.
Type
This selects which type of delay.
Single:
By adjusting the delay time and feedback, you can obtain a
normal delay effect.
Pan:
This delay is specifically for stereo output. This allows you to
obtain the tap delay effect that divides the delay time, then
deliver them to L and R channels.
fig.04-010
Stereo:
The direct sound is output from the left channel, and the
effect sound is output from the right channel.
DlyTime (Delay Time)
This determines the delay time.
* When set to BPM, the value of each parameter will be set
according to the value of the Master BPM (p. 54) specified for
each patch. This makes it easier to achieve effect sound settings
that match the tempo of the song (synchronizing the time to
twice or four times the time length of the BPM when the set
time is increased).
When setting to BPM, press PARAMETER [ ] to display
the Master BPM settings screen.
DlyTime.F (Delay Time Fine)
Make fine adjustments to the delay time.
Tap Time
Adjusts the delay time of the right channel delay. This setting
adjusts the R channel delay time relative to the L channel
delay time (considered as 100%).
Feedback
“Feedback” is returning a delay signal to the input. This
parameter determines the amount of feedback. A higher
value will increase the number of the delay repeats.
High Cut (High Cut Filter)
This sets the frequency at which the high cut filter begins to
take effect. This allows you to get a mild effect sound by
cutting the high-end component above the set frequency.
When it is set to “Flat,” the high cut filter is off or has no
effect.
Effect Level
This adjusts the volume of the delay sound.
After [TAP] is pressed several times, the interval between
presses of the button is then used as the delay time setting.
You can change the Master BPM by setting the delay time to
the BPM and pressing [TAP] several times.
INPUT OUTPUT L
OUTPUT R
Feedback
Delay Time
Effect Level
Effect Level
DELAY
Tap Time