Filter
Top Products
70
Chapter 8 Using the GS-10 with External MIDI Devices Connected
Remote Ctrl (Remote Control)
Valid Settings: Standard, Advanced, MMC
This setting determines the MIDI messages transmitted when
a MIDI sequencer or other external MIDI device is controlled
with a foot switch or other controller connected to the GS-10.
fig.08-090d
Standard:
System Realtime messages are transmitted.
Advanced:
System Realtime messages and Note messages are
transmitted.
MMC:
MIDI Machine Control is transmitted.
* For more details, refer to “Controlling Recorders and
Sequencers Remotely from the GS-10 (Remote Control)”
(p. 75).
* This is set to “Advanced” when shipped from the factory.
KnobCtl Out (Knob Control Out)
Valid Settings: Off, On
fig.08-100d
This setting determines whether or not the information
describing the knob adjustments is output as System
Exclusive messages.
Off:
Knob operations are not output as System Exclusive
messages.
On:
Knob operations are output as System Exclusive messages.
* This is set to “On” when shipped from the factory.
PC Out (Program Change Out)
Valid Settings: Off, On
fig.08-110d
This setting determines whether or not Program Change
messages are output when patches are switched on the GS-
10.
Off:
Program Change messages are not output, even when
patches are switched.
On:
Program Change messages are simultaneously output when
patches are switched.
* This is set to “On” when shipped from the factory.
EXP PDL Out (Expression Pedal Out)
Valid Settings: Off, 1–31, 33–95
fig.08-120d
This sets the controller number when expression pedal
operation data is output as Control Change messages. When
set to “Off, “Control Change messages are not output.
* This is set to “CC# 7” when shipped from the factory.
CTL1 Out (Control 1 Out)
Valid Settings: Off, 1–31, 33–95
fig.08-130d
This sets the controller number when operation data from
the external pedal connected to the CTL 1 jack is output as
Control Change messages. When set to “Off, “Control
Change messages are not output.
* This is set to “Off” when shipped from the factory.
CTL2 Out (Control 2 Out)
Valid Settings: Off, 1–31, 33–95
fig.08-140d
This sets the controller number when operation data from
the external pedal connected to the CTL 2 jack is output as
Control Change messages. When set to “Off, “Control
Change messages are not output.
* This is set to “Off” when shipped from the factory.