Filter
Top Products
148
Installing & Setting Up the Driver (Macintosh)
OMS settings
If other MIDI devices are connected, you must turn off the power on all devices, and then make OMS
settings according to the following procedure.
For more on connecting MIDI sound modules, refer to the owner’s manual for the MIDI sound
module you are using.
1.
Before connecting the USB cable, switch the GS-10’s driver mode to “Advanced.”
For instructions on switching the GS-10’s driver modes, refer to “Switching the Driver Mode” (p. 80).
2.
With the power switch turned OFF, use the USB cable to connect the GS-10 to
your computer.
3.
Make sure that the GS-10’s OUTPUT LEVEL is set to the lowest setting, then
switch ON the POWER switch.
4.
In the “Opcode” folder, open the “OMS Applications” folder, and double-click
the “OMS Setup” icon.
fig.11-400
* The first time OMS is started up, a “Create a New Studio Setup” dialog box will appear. Click [OK]. If this is
the second or later time, select “New Studio Setup” from the File menu.
fig.11-401
* If the “Apple Talk” dialog box appears, select [Turn It Off]. Then click [OK] in the dialog box that appears next.
fig.11-410
The “OMS Driver Search” dialog box will appear.
fig.11-420
Turn on power to your various
devices in the order specified.
By turning on devices in the
wrong order, you risk causing
malfunction and/or damage to
other devices.
This unit is equipped with a
protection circuit. A brief
interval (a few seconds) after
power up is required before
the unit will operate normally.