Filter
Top Products
52
Chapter 4 Introduction to Effects and Parameters
Velocity
This adjusts the amount of the volume change of the
synthesizer sound. When it is set to high, the volume change
will be greater depending on the picking strength. When it is
set to “0,” no volume change is caused even by changing the
picking manner.
Hold
The hold function can sustain the output of the synthesizer
sound. If you turn on the hold while a synthesizer sound is
being output, the synthesizer sound will be held until you
turn it off.
* It is assumed that this parameter will be assigned (p. 60) to the
foot switch.
* This parameter is used when “Square” or “Saw” is selected for
the wave.
Synth Level
Adjusts the volume of the synthesizer sound.
Direct Level
Adjusts the volume of the direct sound.
BS (Bass Simulator)
Simulates the sound of a bass guitar. Obtain the sound of a
bass guitar while playing an electric guitar.
* You should avoid playing chords when using the Bass
Simulator.
Parameter Value
Character Loose, Tight
Level 0–100
Character
Bass tone characteristic is set. When “Loose” is selected, the
sound becomes as if the string gauge was getting thicker.
Level
This adjusts the volume of the bass simulator.
SEQ (Stereo Equalizer)
This adjusts the tone as a stereo equalizer. A parametric type
is adopted for the high-middle and low-middle range.
Parameter Value
Low EQ -20 dB–+20 dB
Lo-Mid f 20.0 Hz–10.0 kHz
Lo-Mid Q 0.5–16
Lo-Mid EQ -20 dB–+20 dB
Hi-Mid f 20.0 Hz–10.0 kHz
Hi-Mid Q 0.5–16
Hi-Mid EQ -20 dB–+20 dB
Hi EQ -20 dB–+20 dB
Level -20 dB–+20 dB
Low EQ (Low Equalizer)
Adjusts the low frequency range tone.
Lo-Mid f (Low-Middle Frequency)
Specify the center of the frequency range that will be
adjusted by the “Lo-Mid EQ.”
Lo-Mid Q (Low-Middle Q)
Adjusts the width of the area affected by the EQ centered at
the “Lo-Mid f.” Higher values will narrow the area.
Lo-Mid EQ (Low-Middle Equalizer)
Adjusts the “Lo-Mid f” range tone.
Hi-Mid f (High-Middle Frequency)
Specify the center of the frequency range that will be
adjusted by the “Hi-Mid EQ.”
Hi-Mid Q (High-Middle Q)
Adjusts the width of the area affected by the EQ centered at
the “Hi-Mid f.” Higher values will narrow the area.
Hi-Mid EQ (High-Middle Equalizer)
Adjusts the “Hi-Mid f” range tone.
High EQ (High Equalizer)
Adjusts the high frequency range tone.
Level
Adjusts the volume after the equalizer.