Filter
Top Products
31
Chapter 4 Introduction to Effects and Parameters
Section 4
EDIT CUSTOM SP 1 –2
Parameter Value
Speaker Size 5”–15”
Color Low -10–+10
Color High -10–+10
Speaker Num x1, x2, x4, x8
Cabinet Open, Close
Mic Type
This setting selects the simulated mic type.
Mic Dis. (Mic Distance)
Simulates the distance between the mic and speaker.
Off Mic:
This setting points the mic away from the speaker.
On Mic:
Provides conditions whereby the mic is directed more
towards the speaker.
Mic Pos. (Mic Position)
This simulates the microphone position. “Center” simulates
the condition that the microphone is set in the middle of the
speaker cone. “1-10” means that the microphone is moved
away from the center of the speaker cone.
Mic Level
Adjusts the volume of the microphone.
Direct Level
Adjusts the volume of the direct sound.
COMP (Compressor)
This is an effect that produces a long sustain by evening out
the volume level of the input signal. You can also use it as a
“limiter” to suppress only the sound peaks and prevent
distortion.
Parameter Value
On/Off Off, On
Sustain 0–100
Level 0–100
On/Off (Effect On/Off)
Turns the COMP effect on/off.
Sustain
Adjusts the range (time) over which low-level signals are
boosted. Larger values will result in longer sustain.
Level
Adjusts the volume.
DYN57
General dynamic mic used for instruments
and vocals. Optimal for use in miking gui-
tar amps.
DYN421 Dynamic mic with extended low end.
CND451
Small condenser mic for use with instru-
ments.
CND87 Condenser mic with flat response.
FLAT
Simulates a mic with perfectly flat re-
sponse. Produces a sonic image close to
that of listening to the sound directly from
the speakers (on site).