Filter
Top Products
7 - 1
7.1 Programming Procedure
7
PROGRAMMING
CHAPTER7 PROGRAMMING
This chapter describes the programs of the QD64D2.
When applying any of the program examples introduced in this chapter to the actual
system, verify the applicability and confirm that no problems will occur in the system
control.
7.1 Programming Procedure
Create a program activating a count by the QD64D2 by the following procedures.
Figure 7.1 Program creation procedures
NO
YES
Program creation start
Set buffer memory
with GX
Configurator-CT.
Turn OFF the
counter value coincidence
No.m when using the
coincidence output
function?
Coincidence signal No. m
reset command ON
To the next page
with sequence program.
Ring counter
setting program
Preset value
setting program
Coincidence output
function setting program
Continuous comparison
function setting program
Initial setting program
*1: Created according to the
functions used.
*2: Turn OFF the coincidence signal No.
m reset command with coincidence
output function program.
*3: If unnecessary on a program, the
signal needs not to be created.
*1
*1
*1
*2
Turn ON the initial setting
complete signal
(any given device).
*3