Filter
Top Products
2 - 3
2.1 Applicable Systems
2
SYSTEM CONFIGURATION
(b) Mounting to a MELSECNET/H remote I/O station
The following table shows network modules that can be mounted to the QD64D2,
the number of mountable network modules, and applicable base units.
The QD64D2 module can be mounted into any I/O slots
*1
on the applicable base
unit.
However, the power capacity may be insufficient depending on the combination
with the other mounted modules and the number of mounted modules.
Be sure to check the power capacity when mounting the modules.
T
: Applicable : N/A
* 1 Limited within the range of I/O points for the network module.
* 2 Can be installed to any I/O slot of a base unit.
* 3 The coincidence detection interrupt function is not supported.
Remark
The Basic model QCPU or C Controller module cannot create the MELSECNET/
H remote I/O network.
Table 2.2 Mountable network modules, No. of mountable modules, and mountable base unit
Mountable network
module
*3
Number of
mountable
modules
*1
Applicable base unit
*2
Main base unit on
the remote I/O
station
Extension base unit
on the remote I/O
station
QJ72LP25-25
Up to 64
QJ72LP25G
QJ72LP25GE
QJ72BR15