Mitsubishi Electronics QD64D2 Drums User Manual


 
4 - 4
4.3 Part Names
4
PROCEDURES AND SETTINGS BEFORE
OPERATION
POINT
Even if the fuse of the external coincidence output part is blown, the FUSE LED
does not turn ON unless a voltage is applied to the external coincidence output
power supply terminal.
(1) Connectors for external wiring
Purchase the connector for the QD64D2 separately.
The following tables show the recommended connector types and crimp tool.
(a) Connector types
* The A6CON3 connector (pressure welding type, straight out) cannot be used for the QD64D2.
(b) Connector crimp tool
Table 4.3 Connector types
Type Model
Soldering type, straight out A6CON1
Crimp type, straight out A6CON2
Soldering type, usable for both straight out and
diagonal out
A6CON4
Table 4.4 Connector crimp tool
Type Model Applicable wire size Contact
Crimp tool FCN-363T-T005/H AWG28 to 24
FUJITSU COMPONENT
LIMITED