Filter
Top Products
6 - 1
6.1 Utility Package Functions
6
UTILITY PACKAGE (GX Configurator-CT)
CHAPTER6 UTILITY PACKAGE (GX Configurator-CT)
6.1 Utility Package Functions
Table 6.1 shows the functions of the utility package.
Table 6.1 Utility package (GX Configurator-CT) functions list
Function Description Reference
Initial setting
(1) Make the initial settings for each channel to operate the QD64D2.
Set the values of the items where initial settings are required.
• CH Ring counter lower limit
• CH Ring counter upper limit
• CH Preset value setting
• CH Coincidence output No.1 point setting
• CH Coincidence output No.2 point setting
• CH Coincidence output No.1 point change request
• CH Coincidence output No.2 point change request
• CH Continuous comparison No.1 start point setting
• CH Continuous comparison No.1 repeat point setting
• CH Continuous comparison No.1 ON time setting
• CH Continuous comparison No.1 point n setting (n: 1 to 16)
• CH Continuous comparison No.2 start point setting
• CH Continuous comparison No.2 repeat point setting
• CH Continuous comparison No.2 ON time setting
• CH Continuous comparison No.2 point n setting (n: 1 to 16)
(2) Data with initial settings are registered to programmable controller CPU parameters and are
automatically written to the QD64D2 when the programmable controller CPU is in RUN.
Section 6.4
Auto refresh
(1) Set the buffer memory of the QD64D2 to which auto refresh is to be performed for each
channel.
• CH Present value
• CH Latch count value
• CH Overflow detection flag
• CH External I/O status monitor
• CH Error code
• CH Warning code
• CH Continuous comparison No.1 point monitor during comparison
• CH Continuous comparison No.2 point monitor during comparison
(2) The values stored in the QD64D2 buffer memory with auto refresh setting are automatically
read when the programmable controller CPU executes the END instruction.
Section 6.5